SDS MATERIAL SAFETY DATA SHEET
SECTION I – PRODUCT IDENTIFICATION
1. Manufacturer : Southland Distribution & Sales
2. Name : Bio Lube™ Synthetic Handpiece Lubricant
3. Product use : Synthetic lubricant for dental handpiece lubrication
4. Toxicity : Not a controlled product
5. Formula : A proprietary synthetic, biodegradable, non-toxic lubricant
6. Transportation : DOT Hazard Class—Not Regulated
SECTION II – PHYSICAL DATA
1. Physical State : Clear Liquid
2. Color. ASTM : < 0.5
3. Specific Gravity : 0.835 @ 15.6° C (60° F)
4. Flash Point : > 266° C (> 510° F), Open Cup
5. Pour Point : -54 ° C (-65 ° F)
6. Refractive Index : 1.4615 @ 25 ° C (77 ° F)
7. Evaporation Loss : 22h, 0.7 @ 150 ° C (302 ° F)
8. Aniline Point : 134.6 ° C (274.3 ° F)
9. Surface Tension : 30.2 Dynes/cm @ 24 ° C (75 ° F)
10. Total Acid Number : < 0.05 mg/KOH/g
11. Kinematic Viscosity : 10 cSt @ 100 ° C (212 ° F), 66 cSt @ 40 ° C (104 ° F)
SECTION III – REACTIVITY DATA
1. Chemical Stability : Stable
2. Reactivity : Nil
3. Hazardous decomposition product : Carbon monoxide
4. Hazardous polymerization : Will not occur
5. Incompatibility : Avoid contact with strong oxidizing agents
SECTION IV – FIRE AND EXPLOSION DATA
1. Flammability : Low Hazard. Product is non-flammable at ambient temperature, liquid may burn at temperatures near the boiling point.
2. Extinguishing Agents : Dry chemical, CO 2, Water Spray, Foam, Water Fog and Sand Earth.
SECTION V – TOXICOLOGICAL PROPERTIES
1. Oral toxicity : Practically non-toxic, LD50 > 2000 mg/kg
2. Dermal toxicity : Practically non-toxic, LD50 > 2000 mg/kg
3. Inhalation toxicity : Practically non-toxic, LD50 > 5 mg/l
4. Eye irritation : Practically non-irritating, Draize score: 0 or >, but < 6.
5. Skin irritation : Practically non-irritating, Primary Irritation Index, 0.5 or less.
SECTION VI - HEALTH HAZARD DATA
1. Permissible concentration : Air 5 mg/m 3 for oil mist, re: OSHA
2. Eyes : Flush with water. If irritation continues, consult physician.
3. Skin : N/A
4. Inhalation : N/A
5. If swallowed : Call physician, do not induce vomiting.
SECTION VII – ECOLOGICAL INFORMATION
1. Ecotoxicity : Not expected to be harmful to aquatic organisms (LL50 or EL50 >100mg/L). Not expected to cause long-term adverse effects based on chronic test data (invertebrate Daphnia magna NOEL >= 100 ppm). Based upon test data for a similar product.
Mobility, persistence and degradability and bioaccumulative potential not established.
SECTION VIII - LEAKS OR SPILLS
Lock off leak and/or source of spill. Remove all sources of ignition and where possible, uncontaminated equipment/items. USE CAUTION AS EXPOSED SURFACES MAY BE EXTREMELY SLIPPERY. Using saturation techniques, soak up leaked and/or spilled solutions with absorbent material. Dispose of saturated materials in accordance with Federal, State and local regulations.
SECTION IX - PREPARATION OF MATERIAL
Bio Lube believes the statements, technical information and recommendations contained herein are reliable, however they are given without warranty or guarantee or any kind, express or implied, and Bio Lube assumes no responsibility for any loss, damage or expense, direct or consequential, arising out of their use.
Southland Distribution & Sales
www.sdssouthland.com
1-800-880-0240/Fax 706-650-7468
info@sdssouthland.com
Bio Lube Lubricant FAQ
Bio Lube Lubricant Instructions
STEP 1 - LUBRICATE
1. Lubricate with Bio Lube™ Lubricant
(short 1 second burst).
2. Run handpiece 15-20 seconds to
expel excess lubricant.
3. Wipe excess lubricant from handpiece.
4. Bag and sterilize in Autoclave or Chemclave.
5. Remove handpiece from sterilizer and
return to service.
NO LUBRICATION
NEEDED AFTER STERILIZATION
•Non-Conductive
•No Flash Point
•No Carbon Tetrachloride
CAUTION: CONTENTS UNDER PRESSURE.
Do not puncture or incinerate container. Do not expose container to heat or store at temperatures exceeding 50˚C(122˚F). If exposed to skin or eyes, flush with water. KEEP OUT OF REACH OF CHILDREN.
Southland Distribution & Sales
www.sdssouthland.com
1-800-880-0240/Fax 706-650-7468
info@sdssouthland.com
